Analysis of the Degradation of Depletion-Mode GaN High-Electron-Mobility Transistors under Reverse Pulse Electrical Stress Using the Voltage-Transient Method

A numerical calibration of structure-function transient thermal measurement based on Cauer RC network

A thermal boundary resistance measurement method based on a designed chip with the heat source separated from the temperature sensor

Measurements of thermal boundary resistance (TBR) are of great significance in the fields of electronic packaging and thermal management. In this study, a measurement method based on a designed 1 × 1 mm2 chip with a heat source separated from a temperature sensor was developed. The chip consists of a temperature sensor with nine Schottky diodes connected in series and a heat source composed of metal wires, which are separated by SiO2 to realize electrical isolation. With this chip, the TBR of samples can be extracted from transient temperature response curves of GaN on a Si wafer using the structure function and transient dual interface test methods. In particular, the surface of samples was etched with uniform arrays to increase the measurement accuracy. The TBR measurements of four samples etched on the same wafer under different conditions were 1.62 ± 0.22 × 10−8, 1.6 ± 0.38 × 10−8, 1.49 ± 0.18 × 10−8, and 1.6 ± 0.35 × 10−8 m2K/W, indicating consistency of the results. This chip effectively expands the application of the structure function method to TBR measurements, which can be helpful for further research on interfacial heat transport.

Identification of Traps in p-GaN Gate HEMTs During OFF-State Stress by Current Transient Method

Characterization of hole traps in reverse-biased Schottky-type p-GaN gate HEMTs by current-transient method

In this study, the current-transient method has been conducted to investigate the trap states in p-GaN gate high-electron-mobility transistors (HEMTs) under reverse gate stress. An irregular threshold voltage shift under reverse gate bias has been observed through the pulsed transfer measurements with different delay times. It suggests that both the hole insufficiency and hole trapping are generated during the reverse gate pulse bias. With proper selection of the delay time based on the pulsed characterizations, the hole detrapping can be effectively evaluated after the hole recovery is completed. In addition, by subtracting the trapping behavior caused by the measurement condition, the actual detrapping transient under reverse gate filling voltages can be obtained with the current-transient method. Three traps have been observed with the energy levels of 0.484, 0.390, and 0.235 eV. The identification of hole traps may provide a basis on the understanding of threshold voltage instability and further improvement of the reliability of p-GaN gate HEMTs.

Characterization of traps in GaN-based HEMTs by drain voltage transient and capacitance deep-level transient spectroscopy

Abstract This paper presents a detailed investigation of trapping effect in AlGaN/GaN high-electron-mobility transistors based on the pulsed current–voltage characterization, drain voltage transient (DVT) measurement, and capacitance deep-level transient spectroscopy (C-DLTS). By monitoring the DVTs at various filling voltages and temperatures, the properties of three electron traps were obtained with the DVT measurements. Specifically, the energy levels of the former two traps were determined to be 0.28 and 0.48 eV, which was confirmed by the C-DLTS measurement performed on the same device. In addition, a third temperature-independent trap located in the GaN buffer was observed only with the DVT measurement, indicating the advantage of transient curves measurement in characterizing the traps insensitive to temperature. The combined measurements demonstrate the correlation of different techniques, which allows identifying the same trap levels to investigate the physical origin of traps.

Research on transient thermal behavior of semiconductor lasers under pulse current excitation by thermoreflection technique

Research on temperatures located within facet coating layers along z-axis of semiconductor lasers

Analysis of the Effects of High-Energy Electron Irradiation of GaN High-Electron-Mobility Transistors Using the Voltage-Transient Method

Identifying the Properties of Traps in GaN High-Electron-Mobility Transistors via Amplitude Analysis Based on the Voltage-Transient Method

Effects of gamma irradiation on GaN high-electron-mobility transistors characterized by the voltage-transient method